CCTV recording retention is not a fixed number built into the recorder. An NVR or DVR keeps footage until the hard drive is full, then either overwrites the oldest files or stops, depending on its settings, and it can also delete files after a period you set. The real number of days depends on drive capacity, the number of cameras and each camera’s bitrate. On the legal side, the implementing regulation of the Saudi Security Surveillance Cameras Law ties the retention period to the Security Terms and Requirements Document. This guide shows how to calculate retention days, how to check them on your recorder, and what the regulation actually says about keeping and handing over footage. If you are planning a new system, see AZEIDK’s security and surveillance solutions.
Key takeaways
- A recorder keeps footage until the drive fills, then overwrites the oldest files or stops, depending on the setting.
- Retention days = drive capacity ÷ (number of cameras × daily consumption per camera).
- A camera at 2 Mbps uses about 21.6 GB per day on continuous recording.
- The implementing regulation refers the retention period to the Security Terms and Requirements Document published on the Ministry of Interior website.
- After a reported security incident, footage is kept until the investigation ends or the period in that document, whichever is longer.
In this article
- How long do CCTV cameras keep recordings?
- How many days will my CCTV record? The retention calculation
- What extends or shortens CCTV storage time?
- How to check the actual retention on your recorder
- Maximum CCTV storage time: how to extend it
- What the Saudi Security Surveillance Cameras Law says about CCTV recording retention
- Handing over footage to the authorities
- FAQ
- Conclusion
How long do CCTV cameras keep recordings?
Short answer: as long as the drive allows. A recorder does not count days on its own; it writes files until the disk is full. What happens next depends on the configuration: it overwrites the oldest footage and carries on, or recording stops and an HDD Full alert appears. Two identical recorders can therefore keep very different periods because the cameras behind them differ.
Four factors decide retention on any site:
- Drive capacity: the total capacity of the disks in the recorder.
- Number of cameras: each one adds its own daily consumption.
- Bitrate: driven by resolution, frame rate, compression (H.264 or H.265) and the scene itself.
- Recording mode: continuous all day, or motion and events only.
On top of these, some recorder settings can shorten retention on purpose; they are covered in the section on checking your recorder.
How many days will my CCTV record? The retention calculation
The calculation is simple once you know each camera’s bitrate, which you will find in the encoding settings for each channel on the recorder or in the camera’s web interface. Convert the bitrate in megabits per second to daily consumption like this:
Daily consumption (GB) = bitrate (Mbps) × 86,400 seconds ÷ 8 ÷ 1,000
Then: retention days = drive capacity (GB) ÷ (number of cameras × daily consumption per camera).
| Camera bitrate | Daily consumption, continuous recording |
|---|---|
| 1 Mbps | about 10.8 GB |
| 2 Mbps | about 21.6 GB |
| 4 Mbps | about 43.2 GB |
| 6 Mbps | about 64.8 GB |
| 8 Mbps | about 86.4 GB |
Example 1: eight cameras at 2 Mbps each, continuous recording, on a 4 TB (4,000 GB) drive. Daily consumption is 8 × 21.6 = 172.8 GB, so retention is about 4,000 ÷ 172.8 ≈ 23 days.
Example 2: the same eight cameras at 4 Mbps on a 10 TB drive. Daily consumption is 345.6 GB and retention is about 28 days. That fits a recorder such as the Hikvision DS-7608NXI-K1(B), whose product page lists 8 channels, 80 Mbps incoming bandwidth and one SATA bay for a drive of up to 10 TB.
Always round down, because usable capacity after formatting is slightly lower than the figure printed on the drive. For a fuller calculation that covers RAID and network bandwidth, see CCTV storage and bandwidth calculation for NVR systems.
What extends or shortens CCTV storage time?
| Factor | Effect on retention days |
|---|---|
| Higher resolution or frame rate | Raises bitrate, so fewer days |
| H.265 instead of H.264 | Lowers bitrate for roughly the same quality, so more days |
| Motion recording instead of continuous | More days, but the gain depends on how busy the area is |
| More cameras on the same drive | Capacity is shared by more channels, so fewer days |
| An extra or larger drive | More days, roughly in proportion to the added capacity |
On compression: when the ITU approved H.265 (HEVC) in January 2013, it stated that the new standard needs only half the bitrate of its predecessor, H.264. Real savings on surveillance cameras vary by scene, so measure them on the recorder after commissioning rather than assuming them. If you move to higher resolution cameras such as 4K (8 MP) CCTV cameras, redo the calculation before buying drives.
How to check the actual retention on your recorder
The calculation gives an estimate; the recorder gives the real figure. Once the drive has filled at least once:
- Open Playback and find the oldest available date for each channel. The Hikvision NVR manual describes searching by channel number, recording type, start time and end time.
- The gap between today and that date is the actual retention for the channel. Channels can differ if their bitrates or recording modes differ.
- Check disk status in the storage menu. A disk showing Uninitialized or Abnormal is not recording and needs attention.
- Review the settings that can shorten retention without anyone noticing, listed below.
| Setting (Hikvision) | What it does |
|---|---|
| Expired Time | How long a recorded file is kept on the drive before deletion. A value of 0 means files are not deleted by age; actual retention is still limited by drive capacity. |
| Overwrite mode | When the drive is full, the oldest footage is overwritten instead of recording stopping. |
| Quota | Allocates a fixed capacity to each camera. A value of 0 lets all cameras share the full capacity. |
| Read-only disk | Protects footage from being overwritten; if it is the only disk, recording stops. |
Menu names vary slightly between firmware versions, and other brands use different names for equivalent settings, so check the manual for your model. Repeat the check whenever cameras are added or resolution changes, because retention changes with them.
Maximum CCTV storage time: how to extend it
- Choose a recorder with enough drive bays from the start. A single SATA bay caps you at one drive. Our guide to choosing a CCTV recorder covers channels and drive bays.
- Enable H.265 or H.265+ where both cameras and recorder support it, then measure the new bitrate.
- Set quotas for critical cameras such as entrances and cashier points, so secondary cameras cannot use up all the capacity.
- Use motion recording outside working hours in areas that are quiet at night, and keep continuous recording during working hours.
- Do not cut resolution until detail is lost. Long retention is worthless if faces and plates cannot be read.
What the Saudi Security Surveillance Cameras Law says about CCTV recording retention
The Security Surveillance Cameras Law was issued by Royal Decree No. (M/34) dated 7/3/1444 AH. Ministerial Decision No. (22688) dated 3/11/1444 AH approved its implementing regulation and the Security Terms and Requirements Document, and was published in Umm Al-Qura on 20/11/1444 AH (9 June 2023). The decision provides for the Terms Document and the site sensitivity classification to be published on the Ministry of Interior website.
What the implementing regulation says about retention, as published in Umm Al-Qura (our translation):
- Article 6(1): when a security incident is reported, the person responsible for the place, activity or facility is notified and signs a written undertaking to keep the recordings until the investigation ends or for the period set in the Terms Document, whichever is longer.
- Article 10: parties other than those authorised may not keep recordings contrary to the period set in the Terms Document.
- Article 3(b): all storage media must be dedicated to the security surveillance system devices only.
In practice, the number of days your facility needs comes from the current Terms Document on the Ministry of Interior website, not from a figure repeated on forums. Article 10 also means that keeping footage longer than the stated period is not an open choice for unauthorised parties, so buying the biggest drive available is not the answer. Size storage to cover the required period plus a margin for footage held after an incident, then set Expired Time to match. For the other obligations (camera locations, privacy, licensing), see Saudi Security Surveillance Cameras Law: facility obligations.
Handing over footage to the authorities
The regulation also sets the handover route. Article 6(2) requires those responsible for places, activities or facilities covered by the law not to hand over recordings except on an official request from the enforcement bodies of the Ministry of Interior and the State Security Presidency. Article 9 states that a request to transfer recordings, explaining the reasons for the transfer, is submitted on the electronic platform.
In practice, do not wait until footage is requested after an incident: identify the channel and time, and protect the clip from being overwritten (lock or copy it), because the recorder will keep overwriting the oldest files according to its settings. Release footage only against the official request the regulation describes.
FAQ
How long is CCTV footage kept on a typical recorder?
There is no single figure. Eight cameras at 2 Mbps on a 4 TB drive give about 23 days of continuous recording, and the number changes with camera count, bitrate and drive size.
Does Saudi law set the number of retention days?
The implementing regulation refers the period to the Security Terms and Requirements Document published on the Ministry of Interior website. Check the current document for your type of facility and use the figure it gives.
What happens when the CCTV hard drive is full?
With overwrite enabled, the recorder deletes the oldest footage and continues. Without it, recording stops and an HDD Full alert appears.
How can I see how many days my CCTV keeps?
Open Playback and find the oldest recording on each channel. The gap to today is the real retention, provided the drive has filled at least once.
Does motion recording double retention?
It extends it, but not by a fixed ratio. A quiet area saves a lot; a busy entrance gets close to continuous recording.
Can I give footage to someone who asks for it after an incident?
The regulation says recordings are handed over only on an official request from the enforcement bodies of the Ministry of Interior and the State Security Presidency, and transfer requests go through the electronic platform.
Conclusion
CCTV recording retention equals drive capacity divided by the daily consumption of all cameras, then limited by the recorder’s settings. The legally required period comes from the Security Terms and Requirements Document that the implementing regulation refers to. Size storage for that period, check the oldest recording on the recorder after commissioning, and recheck after any change to the cameras.
Need to know how many days your system needs and how much storage that takes? Send us the number of cameras, their resolution and the period your facility requires, and our team will propose the recorder and drives. Talk to the AZEIDK team
Related guides
- ZKTeco Access Control: Standalone or Networked, and Which Software
- ZKTeco in Saudi Arabia: Access Control, Time Attendance and Turnstiles
- Emergency Exit Doors in Saudi Arabia: Fire-Rated or Not, Swing, Width, Panic Bars and Inspection
- Water Mist Fire Suppression in Saudi Arabia: Applications and Technical Considerations







