Request a Quote

AZEIDK Group Our Services

Testing & Commissioning

Testing fire protection and fire alarm systems, verifying their operation, and confirming the required system responses.
Testing, Commissioning & Handover

AZEIDK Specialized Services

Service Overview

The testing and commissioning stage helps verify that system components are functioning properly and that their functions are integrated within the project scope.

Testing and commissioning represent an important verification stage before handover. Fire protection and fire alarm systems undergo functional testing and review to assess their readiness, verify the required responses, and identify observations that need to be addressed before final acceptance.

What you receive

  • Written test procedures for each system before work starts.
  • Functional test results: detector and call-point signals, notification devices, fire pump operation and network pressures, and response sequences and interfaces with other systems.
  • A snag list of items to be corrected, with retesting after correction.
  • The commissioning and test reports needed for the handover file.

References

Testing follows the project’s approved drawings and specifications, manufacturer instructions, Civil Defense requirements and the relevant NFPA standards, such as NFPA 72 for fire alarm acceptance testing, NFPA 20 for fire pump acceptance tests and NFPA 13 for sprinkler systems.

What happens after testing

Once the tests are passed, the work moves to documentation and final handover, after which a preventive maintenance contract can keep the systems ready.

Frequently asked questions

Do you test systems installed by another contractor?
Yes, after reviewing the drawings and the installation condition; any observations found before commissioning are documented.

Can the consultant or owner attend the tests?
Yes, and it is recommended so results can be accepted on the spot.

What We Provide

– Review system readiness and the scope of pre-commissioning inspections.
– Perform functional, signal, and control tests according to the system type.
– Verify response sequences and the included system interfaces.
– Document test results and observations, and repeat testing when required.

Systems Covered by This Service

Alarm and operating systems
Fire pumps and firefighting networks
Response and interface scenarios
Test results and comments

Service Delivery Process

01Prepare the test plan
02Check readiness and connections
03Run the systems and test the scenarios
04Document results and close comments

Industries We Serve

Getting ready to test and commission your safety systems?

Contact the AZEIDK Group team to discuss your facility’s testing and commissioning requirements, identify the appropriate technical steps, and define a suitable scope of work.
Contact the AZEIDK Team
This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.